Information" Mode; Means Of Measurement, Tools And Accessories; Marking And Sealing; Packing - NOVOTEST UD3701 Operation Manual

Operation manual
Ultrasonic Flaw Detector NOVOTEST UD3701
1.7.5 «INFORMATION» mode
This mode contains information about dealers.

1.8 Means of measurement, tools and accessories

The correct work of the device is checked on calibration blocks. Mismatch readings must not
exceed the permissible error. If the permissible error is exceeded, the device should be calibrated in
accordance with p. 2.3.10.
In case of device defect, the manufacturer is obliged to make adjustment and installation of the
device.

1.9 Marking and sealing

There is a label with device type and trademark of the manufacturer on the front panel of the
device.
The serial number is printed on the back panel, under the battery compartment cover.

1.10 Packing

The electronic unit and probes are delivered in a package (case), excluding their damage during
transportation.
To avoid mechanical damage to the cable and connectors of the device, it is necessary to
disconnect probes from the device before packing it into the package
Page 25
Figure 1.21 – «RESULTS» mode