Connecting The Device To Pc; Software Installation Awp_Ud3701 - NOVOTEST UD3701 Operation Manual

2.6 Connecting the device to PC

2.6.1 Software installation AWP_UD3701

While the device is connected to PC, user can send data from the device and vice-versa on the
device (Flash mode of memory). In the device saved data is stocked in archive.
For device connection to PC, user should do the following:
1. Copy driver «CP210x_VCP_Windows» and program «AWP_UD3701» to PC hard drive or
download actual version from the official site.
2. After downloading, open archive - two folders will be available: one with driver and other
with program (Figure. 2.74).
3. Install driver on PC.
Note – After message about successful downloading it is recommended to restart PC
4. Now the device could be connected to PC via USB cable from the standard delivery set. After
connection, PC founds a new device and starts required driver.
5. Install the program for device operation. For this launch installation file (setup.exe) from
folder «AWP_UD3701» and click «Install» (Figure. 2.75).
6. After installation finished, the program starts automatically and program label
«AWP_UD3701» appears on the PC desktop.
Ultrasonic Flaw Detector NOVOTEST UD3701
Figure 2.74 – Software downloaded
Figure 2.75 – Installation AWP_UD3701
Operation manual
Page 58