Table of Contents
Advertisement
The device by type of performance and taking into account operating conditions refers to products
that are repaired at special enterprises or at the manufacturer.
To set the device for warranty service in the service center (SC), it is necessary to present
correctly completed passport for the device. SC makes a mark in the passport about setting the device
for warranty service and sends a photocopy to the manufacturer.
Sending the device for warranty (post-warranty) repair or verification should be done with the
passport of the device. In the accompanying documents it is necessary to indicate the mailing details,
telephone and fax of the sender, as well as the way and the address of the return delivery.
Warranty repair is carried out in the presence of a completed passport.
Store the device at an ambient temperature of +5 ° C to +40 ° C and relative humidity up to 80%
at a temperature of 25 ° C.
Storage of the batteries of accumulators (BA) should be carried out in a charged state separately
from the device in a dry premise. Duration of storage of the fully charged BA in the detached state:
at a temperature from -20 ° С to +35 ° С - no more than 1 year;
at a temperature from -20 ° С to +45 ° С - no more than 3 months.
Recommended temperature for long-term storage 10 ° C - 30 ° C.
At the end of the shelf life, the batteries should be recycled.
In the case of short-term storage and during interruptions between applications, the device must be
stored in a suitable packaging container. In the storage place there should be no vapors of corrosive
substances (acids, alkalis) and direct sunlight. The device must not be subjected to sudden shocks, falls
or strong vibrations.
Devices should be stacked on shelves or stacked in transport packaging.
For long-term storage, the device must be preserved, for which the electronic unit, probe, power
unit and thickness measures, cleaned of dirt and oil, are placed in separate plastic bags and placed in
separate pockets of the transportation bag of the device.
Packed instruments can be transported by any mode of transport provided the following conditions
are met:
transportation is carried out in factory packaging;
there is no direct exposure to moisture;
the temperature does not exceed -50 ° C to +50 ° C;
humidity does not exceed 95% at temperatures up to 35 ° С;
vibration in the range from 10 to 500 Hz with amplitude up to 0.35 mm and acceleration up to
2
49 m/s
;
impacts with a peak acceleration value of up to 98 m/s
the devices placed in the transport are fixed to avoid falling and collision.
To prevent moisture condensation inside the thickness gauge when transporting it from frost to a
warm room, it is necessary to hold the device for 6 hours at room temperature.
The product does not contain in its design any dangerous or poisonous substances that can harm
human health or the environment and do not pose a threat to life, health of people and the environment
at the end of their service life. In this regard, the recycling of the product can be made according to the
rules for the disposal of general industrial waste. Recycling is carried out separately by groups of
materials: plastic elements, metal fasteners.
The content of precious metals in the components of the product (electronic cards, connectors,
etc.) is extremely small, so it is not appropriate to produce their secondary processing.
Ultrasonic Flaw Detector NOVOTEST UD3701
4 MAINTENANCE
5 STORAGE
6 TRANSPORTATION
2
7 RESYCLING
Operation manual
;
Page 74
Advertisement
Table of Contents
