Cable Installation For The Mp-Tp17 Back Box; Finalizing The Installation - AMX Modero NXT-1500VG Operation/Reference Manual

Ten
#6-32
securing
screws
Internal panel casing
Four (pan-head) Housing Screws
FIG. 52 Location of the attachment screws on the NXD back box and VESA housing

Cable Installation for the MP-TP17 Back Box

1. Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective
locations along the side of the touch panel.
2. Use the tie-wrap (45-0009A) to wrap the cables together inside the VESA Mount enclosure. This
cable tie is used to insure the cable will not pull through or work itself through the new larger strain
relief grommet (45-0032-01) over time.
3. Thread the incoming cables through the hole on the rear plastic cover and then through the strain
relief grommet.
4. Slide the grommet along the cable and securely insert it into the opening on the rear plastic cover
(FIG. 52).

Finalizing the installation

1. Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP17 back box).
2. Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open
strain relief grommet.
3. Allow some slack/length on these cables as a service loop. This service loop provides enough cable
length so you can later remove the NXD (with connected cables) from the rear plastic cover.
VG-Series Modero Touch Panels
DO NOT REMOVE
Connector
opening
Securing
hole locations
(2 on each side)
Rear plastic cover
(60-0033-50)
Installation Procedures: 17" Panels
MB-TP17 back box
(62-0033-50)
Strain relief grommet (Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
Four (#8-32) screws
73