Eastwood PRO MINI ANGLE Instructions Manual page 6

ADJUSTING SANDING ARM ANGLE
Disconnect air supply from the tool to prevent accidental starting and potential
injury while Adjusting Arm Angle.
• Disconnect air supply from the
tool to prevent accidental starting
and potential injury while adjust-
ing the Abrasive Belt Arm Angle.
• Using the included 4mm Hex Key,
loosen the Angle Adjusting Screw
located on the upper side of the
Abrasive Arm Assembly (FIG 4),
rotate Arm to desired position
then tighten screw securely.
ADJUSTING SANDING ARM ARTICULATION
Disconnect air supply from the tool to prevent accidental starting and potential
injury while Adjusting Belt Tracking.
• Disconnect air sup-
ply from the tool to
prevent accidental
starting and potential
injury while adjust-
ing the Abrasive Belt
Articulation Angle. The
Articulation Adjust-
ment Screw is located
at the outer left side
of the Abrasive Arm
Assembly (FIG 5).
• Using the included 3mm Hex Key, loosen the screw slightly and the outer 2.5" of the arm will
droop and the locking screw head will slide in the curved slot allowing up to 50° of articulation.
NOTE: Spring tension in the Arm must be maintained against the belt to retain it in place or it
will fall off.
6
INJURY HAZARD!
FIG. 4
Rotate
INJURY HAZARD!
FIG. 5
Rotate
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
Maintain Spring Tension
Loosen