Table of Contents
Advertisement
SET UP & CONNECTION
Be sure that the air supply to the tool is clean and dry. Moisture in the supply
line will quickly damage the air motor and valves.
A minimum 3/8" I.D. air line should be used for optimal performance.
• Wrap white thread sealing tape (Not Included) around the threads of the included 1/4"
Male NPT quick disconnect fitting, then thread it into the 1/4" NPT inlet threads of the
Belt Sander Body.
• Attach Air Supply to Inlet Fitting.
4
• This tool has high-speed, abrasive surfaces which can quickly cause injury.
Keep fingers and hands away from moving parts when operating. Wear
thick, well-fitting work gloves and keep loose clothing, sleeves, cords,
jewelry and hair away from moving parts.
• This tool can eject sparks which can ignite flammable materials. Do not
operate near flammable materials and keep all persons and pets away
from the work area.
• Always make sure the workpiece is securely clamped or anchored to avoid
sudden movements which could result in injury.
• Always disconnect tool from air supply when changing Abrasive Belts
or making adjustments to prevent accidental tool starting and potential
severe injury.
• Frequently inspect Abrasive Belt and tool condition. If tears develop,
discontinue tool use immediately and replace damaged belt. ONLY USE
replacement Abrasive Belts rated for 17,000 RPM or greater otherwise
severe injury can result in the event of Belt failure.
• This tool will vibrate during use! Repeated exposure to vibration may
cause physical injury.
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
INJURY HAZARD!
VIBRATION INJURY HAZARD!
Advertisement
Table of Contents
