Application Diagram - GiBiDi TOP EVO 291E/S Instructions For Installation Manual

28
UK
3 - MAXIMUM OPERATING CURVE
The operating time based on the desired operating frequency can be derived from the graphs 2a and 2b .

4 - APPLICATION DIAGRAM

The maximum leaf lenght related to the weight can be derived from the graph 2c .
5 - DIMENSIONS
[3]
Refer to figure .
6 PRELIMINARY WARNINGS -
• Check that the gate structure is adapted for installing the operator.
• Check that the fixed and mobile parts of the gate are structurally intact and appropriate or whether require
reinforcement work.
• Check that the parts subject to friction, especially the top hinge, does not require any setup.
• In the working area of the operator there must no obstacles of any kind.
• Check the existence of an efficient earth.
• The installation should be done far away from any road, so as not to pose a threat to circulation.
• It is useful to signal the automatic entrance with easily visible warning plates (inside and outside) and, if
necessary, that warn pedestrians they are not allowed to pass through.
• If the installation presents some unsafety details, stop the work and contact your dealer.
• Check that the gate structure is strong enough. In any case the operator must push the leaf at a reinforced
point.
• Check that the leaves can be moved manually without effort throughout the stroke.
• Check that the mechanical stops, both in opening and closing, are correctly installed.
• If the automatic system is not a completely new installation, check the wear of all components and repare or
replace the defective or worn parts.
• The reliability and safety of the automatic device are directly affected by the condition of gate structure.
TOP EVO
[ ]
[ ]
[ ]