Sav 245.09 Operating Instructions Manual page 68

SAV 245.09 /.10 /.99
Magnetic chuck of the precision sine table does not switch
Magnetic chuck not connected to the control unit. Check the connection.
■
Magnetic chuck defective. Send the precision sine table with electro permanent magnetic chuck/electromagnetic
■
chuck to SAV GmbH for repair.
Control unit not connected to the power supply or defective. Check the control unit.
■
Workpiece not adhering to the magnetic chuck of the
precision sine table
Holding force of the workpiece too low, e.g. due to high-alloy workpieces. Note the information in
■
section 3.1 "Holding forces".
Please note the detailed checklists for troubleshooting in the operating instructions for the SAV polarity reversal
control units.
Contact SAV Service if necessary.
8 TROUBLESHOOTING
[ ]
68
Version 1.0