General Information; Warnings - urmet domus H.265 NVR Quick Manual

EN

General Information

Dear Customer,
Thank you for purchasing this product.
This document describes how to quickly install and use the URMET S.p.A. H.265 series
NVR models. Before using the device, read this document carefully and keep in a safe place where it is easily
accessible for reference when needed.
*NOTE
For further information, see the instruction manual on the Urmet website. To download the manual from the site,
see the QR code on the Addendum sheet.

WARNINGS

Power supply
Before connecting the device to the electrical outlet, ensure that the ratings on the nameplate match those of the
mains power supply.
Do not pull on the cable to unplug the device.
Switch off the device before disconnecting the power. Do not switch the NVR off while recording or playing, or from
the configuration menu. Stop recording and playback before disconnecting the device, to prevent damage to the
hard disk.
Safety precautions
Keep the device away from rain and dampness to prevent the risk of fire or electrocution. Do not introduce any
material (solid or liquid) inside it. If this should accidentally occur, disconnect the device from the mains outlet and
have it inspected by qualified personnel.
Never open the device. In all cases, contact qualified personnel or an authorised service centre for repairs
(www.urmet.com >> Contacts >> Technical Support Centres).
Keep the device away from children, to avoid accidental damage.
Do not touch the device with wet hands to prevent electric shock or mechanical
damage.
Stop using the device if it falls or if the external casing is damaged. Continuing to use the device in these conditions
could cause electric shock. Contact the retailer or authorised installer.
Installation precautions
To prevent the device from overheating, place it in a position that allows a flow of air through the vents in the
casing. Leave a space of at least 5 cm when installing in a rack. For the same reason, do not install near heat
sources such as radiators or hot air ducts.
Keep the device away from direct sunlight. Do not install in areas subject to excessive dust, mechanical vibration or
shock.
Do not place the device on an unstable surface, such as an unsteady or sloping table, as the device could fall,
causing damage or mechanical failure.
Do not install the device where it may be exposed to moisture or water. Do not spray water on the device, to avoid
risk of fire, electric shock or mechanical damage.
Stop using the device if water or any other material penetrates inside it, to prevent risk of fire or electric shock. In
such cases, contact the retailer or authorised installer.
Do not place heavy or heat-generating objects on top of the device: this could damage the casing and/or increase
the internal temperature, leading to damage.
Do not cover the device with a cloth while it is running to prevent deforming the external casing and overheating the
internal parts, causing risk of fire, electrocution and mechanical failure. Keep magnets and magnetised objects
away from the device to avoid malfunction. Do not use the device in the presence of smoke, vapour, humidity, dust
or intense vibrations.
Do not operate the device immediately after moving it from a cold place to a warm place or vice versa. Wait for
around three hours: this will allow the device to adapt to the new ambient (temperature, humidity, etc.).
DS1098-031D 22