Table of Contents
Advertisement
IMPORTANT!
Before washing the bed
– Make sure the power plug is removed from the
wall socket outlet before cleaning.
– Make sure that all plugs on the bed are in place
during washing.
– Check that all motors and the hand control is
correctly connected to the control unit.
– Run the motors all the way down/in to prevent
calcium settlings and corrosion.
IMPORTANT!
After washing the bed
– Flushing must be done after washing.
– Do not cool the bed off with water immediately
after washing.
– The bed must be dry when leaving the washing
tunnel, or when back in room temperature.
– During air-drying, do not exceed a temperature
of 50° C.
Washing
•
Use a water temperature of max. 70° C.
•
Max. duration: 2 min.
•
The water pressure must not exceed 8 bar in a distance
of least 30 cm.
•
The cleaning solvent:
– must have a pH value of 5-8
– must not change the surface structure of plastic parts
– must not dissolve the attached labels
– must not dissolve grease
Flushing
•
Use a water temperature of max. 85° C.
•
Max. duration: 20 sec.
•
Use a flushing solvent with a pH value of 5-8.
Drying
•
Dry the bed after washing.
IMPORTANT!
Check after washing
– Test all functions to ensure proper operation.
– Lubricate the bed according to the lubrication
chart.
Inspection after washing
IMPORTANT!
When the bed has been washed; before given to
a new user it has to be thoroughly inspected.
– Inspection must be done by a trained
professional.
– For regular maintenance see Maintenance
checklist.
Checkpoints
q
Check the locking of the motors (pipe pins correctly
mounted).
1568774-H
q
Check the electronic wiring for the motors (wires not
squeezed).
q
Check that the enclosing of the motors are intact (no
cracks that enables fluids to pierce).
q
Check the sections of the mattress support by using
the hand control to activate all functions of the moving
parts.
q
Check the function of the brakes.
q
Check the locking function(s) of the side rails.
6.2.5 Disinfection Instructions
Information on recommended disinfectants
and methods can be found on https://vah-
online.de/en/for-users.
In Domestic Care
Method: Follow the application notes for the used
disinfectant and wipe-disinfect all accessible surfaces.
Disinfectant: Ordinary household disinfectant.
Drying: Allow the product to air-dry.
In Clinical and Long Term Care
Follow your in-house disinfection procedures and only use
the disinfectants and methods specified therein.
6.2.6 Lubrication
Lubricate with medically clean oil:
A All mattress support hinges
B All bearings for motors
C All bearings for lifting arms
D All motor compression bars
E 6-edged axle at braking pedals
F All top and lower hinges of side rail
Lubricate with medical grease:
G Guideways on base
Maintenance
17
Advertisement
Table of Contents
