Table of Contents
Advertisement
5.10.2 Adjusting the handle height
The handle height should always be adjusted to the user's
need.
1.
A
1. Hold the cord out while sliding the plastic cord lock A
upwards or downwards until the handle reaches the
preferred height.
2. Lock the handle by pressing back the cord in the lock
A and pull the handle downwards.
IMPORTANT!
After adjusting the handle height:
– Check that the two cords above the cord lock
are parallel and inside the cord lock.
– Make sure the cord is properly locked by pulling
the handle hard.
5.11 IV Drop rod
The IV Drop rod is placed in one of the four corner tubes.
5.11.1 IV Drop rod standard
1568774-H
2.
A
1. Place the bushing
B into the desired
corner tube C.
2. Position the IV drop
rod in the desired
height.
3. Tighten the finger
screw A.
5.11.2 IV Drop rod telescopic
Mounting
1.
Remove the screw A and nut B from the bottom of
the IV pole.
2.
Place the drop rod in one of the two head corner
attachments C of the bed and push it all the way down.
3.
Put the screw A and nut B back and tighten.
4. Make sure it is steadily mounted before using.
Change of height
1. Loosen the finger screws C.
2. Pull the pole up to wanted height.
3. Tighten the finger screws C.
Changing position of the hooks
1. Loosen the finger screw D on top of the IV drop rod.
2. Move the hooks to wanted position.
3. Tighten the finger screw D.
Operating the bed
15
Advertisement
Table of Contents
