Alto-Shaam ecosmart 1200-SK/III Marine Manual page 23

User Options
A B C
Preset Buttons Lock and Unlock
Preset buttons A through H can be locked in order to
prevent storing, altering or erasing a program.
To lock the Preset buttons, press and hold the "I"
Button until the oven beeps. Release the "I" button.
The green indicator on the "I" button will illuminate.
Oven Preset Buttons A through H are now locked.
Note: Only the oven Preset buttons A through H are
affected by this lock-out in order to also allow the
oven to be used with the unprogrammed Cook,
Probe, or Hold modes.
To unlock the Preset Buttons, press and hold the
Cancel Button along with the "I" button until you hear a
brief beep. Release all buttons. The green indicator on
the "I" button will extinguish. The oven preset buttons
are now unlocked.
Fahrenheit or Celsius Selection
With the control in the off mode,
press and hold the Up Arrow Button until
the display toggles between Fahrenheit and
Celsius. After each change the button must
be released. The display must clear before
the procedure can be repeated.
Lock
Indicator
D E F G
MN-46411 • Rev 2 • 12/19 • 1200-SK/III Marine Cook, Hold, Smoke
H I CANCEL
Preset
Lock
Control Panel Lock and Unlock
The control panel can be locked at any time in order to
prevent inadvertent or accidental setting changes.
To lock the control panel, press and hold the Up Arrow
Button and then press the On/Off button.
You will hear a brief beep and the panel lock
indicator will illuminate. Release all buttons.
The oven's control panel is now locked.
Note: The control panel is now fully locked with the
exception of the On/Off button and Arrow buttons.
You will be unable to turn the oven control off at
this point.
To unlock the control panel, press and hold the Down
Arrow Button and then press the On/Off button. You
will hear two brief beeps and the panel lock indicator
will extinguish. Release all buttons. The panel is now
unlocked and ready for normal use.
Beeper Volume Selection
With the control in the off mode,
press and hold the Down Arrow button
until the display shows one of the 4
volume levels (0 being off or the lowest,
and 3 being the highest). After each
change, the button must be released
and the display must clear before the
procedure can be repeated to select a
different volume level.
Operation
23