Table of Contents
Advertisement
11. EXPLANATION OF COMPONENTS
2.
FUEL CONTROL DIAL
(WITH AUTO-DECELERATION MECHANISM)
This adjusts the engine speed and output.
Low idling (MIN): Turned fully to the left
Full speed (MAX): Turned fully to the right
3.
CIGARETTE LIGHTER
This is used to light cigarettes. To use, push the lighter in. After a few
seconds it will spring back.
Pull out the lighter and light your cigarett.
Nothing may be connected to the cigarette lighter without the prior
persmission of an authorised Komatsu distributor.
4.
SWING LOCK SWITCH
• When the machine is travelling under its own power, or when
the swing is not being operated, always set the switch to the
ON (ACTUATED) position.
• On a slope, the work equipment may swing to the down side
even if the swing lock switch is located at the ON position. Be
careful concerning this point.
This switch is used to lock the upper structure so that it cannot swing.
ON position (actuated):
The swing lock is always applied, and the upper structure will not
swing even if the swing is operated. In this condition, the swing lock lamp
lights up.
OFF position (cancelled):
The swing lock is applied only when the swing control lever is at neu-
tral; when the swing control lever is operated it is cancelled.
The swing lock is actuated approx. 4 seconds after the swing lever is
placed in neutral.
5.
WIPER SWITCH
This switch actuates the front window wiper.
OFF: the wiper stops
ON: the wiper moves continuously
Window washer fluid is sprayed out: when the switch is released, it
returns to
.
ON: the wiper moves intermittently.
Window washer fluid is sprayed out: when the switch is released, it
returns to
.
2-16
WARNING
Advertisement
Table of Contents
