24.8.2 CHANGE OIL IN FINAL DRIVE CASE
• The oil is at high temperature immediately after the machine
has been operated. Wait for the oil to cool down before carry-
ing out maintenance.
• If there is still pressure remaining inside the case, the oil or
plug may fly out.
Loosen the plug slowly to release the pressure.
Prepare the following.
•
Container to catch drained oil: Min. 2.5 l capacity (PC130),
•
Refill capacity: 2.5 l (PC130),
4.0 l (PC150LGP)
•
Hexagon wrench
1.
Set the machine with plug
surface.
2.
Set a container under plug
3.
Remove plugs
and
4.
Tighten plug
.
5.
Add engine oil through the hole of plug
REMARK
Check the O-rings in the plugs for damage. If necessary, replace with
new ones.
6.
When the oil overflows from the hole of plug
WARNING
Min. 4.0 l capacity (PC150LGP)
and plug
perpendicular to the ground
to catch the oil.
with the hexagon wrench and drain the oil.
.
, install plug
24. SERVICE PROCEDURE
.
3-61