Nexcom Neu-X300 Series User Manual page 73

Chapter 4: BIOS Setup
Secure Boot
Aptio Setup Utility - Copyright (C) 2020 American Megatrends, Inc.
Chipset Security
System Mode Setup
Secure Boot [Disabled]
Not Active
Secure Boot Mode [Custom]
►
Restore Factory Keys
►
Reset To Setup Mode
►
Key Management
Version 2.20.1275. Copyright (C) 2020 American Megatrends, Inc.
Secure Boot
Select this to enable or disable Secure Boot. Secure Boot only works when
the system runs in user mode.
Secure Boot Mode
Select this to configure the Secure Boot mode.
Standard Fixed secure boot policy.
Custom Secure boot policy variables can be configured by a
physically present user without full authentication.
Copyright © 2020 NEXCOM International Co., Ltd. All Rights Reserved.
Key Management
Secure Boot feature is Active
if Secure Boot is Enabled,
Platform Key(PK) is enrolled
and the System is in User mode.
The mode change requires
platform reset
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Factory Key Provision
Select this to enable or disable the installation of factory default secure boot
keys after the platform resets during system setup mode.
59
Aptio Setup Utility - Copyright (C) 2020 American Megatrends, Inc.
Chipset Security
Vendor Keys Valid
Factory Key Provision
[Disabled]
►
Restore Factory Keys
►
Reset To Setup Mode
►
Export Secure Boot variables
►
Enroll Efi Image
Device Guard Ready
►
Remove 'UEFI CA' from DB
►
Restore DB defaults
Secure Boot variable | Size| Keys| Key Source
►
Platform Key(PK) | 0| 0| No Keys
►
Key Exchange Keys | 0| 0| No Keys
►
Authorized Signatures | 0| 0| No Keys
►
Forbidden Signatures | 0| 0| No Keys
►
Authorized TimeStamps | 0| 0| No Keys
►
OsRecovery Signatures | 0| 0| No Keys
Version 2.20.1275. Copyright (C) 2020 American Megatrends, Inc.
Install factory default Secure
Boot keys after the platform
reset and while the System is
in Setup mode
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Neu-X300 Series User Manual