Assembling The Intake System - Stihl 4180 Series Service Manual

7
18
19
17
15
16
Disconnect throttle cable (17) from the lever (7).
N
Remove the throttle rod (8).
N
Turn lever (7) counterclockwise and pull it off.
N
Disconnect ground wire blade receptacle (18).
N
Take out the screws (15).
N
Remove the ground tab (19).
N
Remove the spacer flange (6) together with the
N
screws (16).
Remove the gasket (5).
N
If necessary, remove and replace impulse hose (1).
N
10.3

Assembling the Intake System

5
19
6
Push the screws (16) into the spacer flange (6).
N
Fit the ground tab (19).
N
Push the screws (15) into the spacer flange (6).
N
Fit the gasket (5).
N
Position the spacer flange (6) on the cylinder.
N
Insert and tighten down the screws (15).
N
24
8
6
15
7
18
19
17
Fit sleeve of throttle cable (17) in recess in spacer
N
flange (6).
Fit blade receptacle of ground wire (18) on ground tab
N
(19).
Fit the lever (7).
N
Attach throttle cable (17) to lever (7).
N
10
Attach throttle rod (8) to lever (7).
N
Fit a new gasket (9).
N
Push the carburetor (10) into place.
N
Push the impulse hose (1) onto the carburetor's
N
connector.
Attach the throttle rod (8) to the throttle lever (7).
N
10
4
2
Push the hoses (3, 4) onto the carburetor's
N
connectors.
Fit the gasket (11).
N
Push the hose (2) onto the connector on the filter
N
housing (12).
Push the filter housing (12) into position.
N
6
7
8
13
3
12
Series 4180 Powerhead