13.5
Assembling the Control Handle
2
21
Push the ground wire (21) terminal (21) onto the pivot
N
of lever (2) and then rotate the ground wire (21) into
the slot as far as stop.
Fit lever (2) on the pivot pin and rotate it into the
N
recess.
22
Fit blade receptacle (1) of short circuit wire (22) on
N
contact spring (6).
Push the contact spring (6) in its guides.
N
Starting at the contact spring, fit the short circuit wire
N
in the guides (arrows).
Series 4180 Powerhead
20
2
6
21
Starting at lever (2), press the ground wire (21) into its
N
guides (arrows).
Push the torsion spring (3) onto the pivot pin of lever
N
(2) so that its hooked end engages the lever (arrow).
Pre-tension the straight leg of torsion spring (3) and
N
attach it to the stop (arrow).
Fit the torsion spring (4).
N
3
2
4
35