Table of Contents
Advertisement
61200226L1-1
Accept Numbers
This field designates which numbers this end point will pass on toward the
Network (PSTN). The accept list may consist of multiple entries. The num-
bers are defined using "wild cards":
X =
Any single digit
N = Any single digit 2—9
$ = Any number of digits of any value
9 = This specific number
[1,2,3...] = A single digit in this group
Example: 1-800-$ would only permit toll free long distance calls to 1-800. If
this were used, then a second accept # would need to be specified - NXX-
XXXX. This would permit local numbers to be dialed.
Any specific entry will take precedence over a wild card. For example, if end point
"A" was designated as $ while end point "B" accepted 963-800X, then an incom-
ing call to 963-800X would only be accepted by end point "B".
Data 64 kbps, Analog, Speech, and Treat Call As
These options reflect the bearer capability the Network has provi-
sioned for this line. If the ISDN lines were purchased with different
services provisioned, then ATLAS would send the call out of the port
which supports the type of service the call requires.
Example: The Network Termination is on a pair of BRIs (with the
same phone number) with one provisioned for data and the other for
voice. By enabling data in one and not the other, ATLAS ensures that
calls bearing data will be sent out the right BRI interface.
Search
Write Security: 3 Read Security: 5
Primary Search
The Search parameter instructs ATLAS which order to search for an
accept number match. Normally all searches are set to Primary. The
Secondary search selection would be used to force ATLAS to only
accept a call at this end point if all Primary end points were unavail-
able.
Example: All long distance calls should go out a PRI directly to
an IXC (MCI, ATT, etc.) and local calls should go out a T1 to the
LEC. It may be desirable to place long distance calls on the local
exchange if all of the IXC trunks are unavailable (busy or in
alarm). In this case, the primary accept number for the local
exchange would be N$, and the secondary accept would be 1$.
Secondary Search
The same accept rules apply for all secondary number searches as for
primary searches.
PLUS
_
ATLAS
800
Chapter 5. Using the Terminal Menu
User Manual
5-35
Advertisement
Table of Contents
