Air Diverter Installation Instructions; Hanging Instructions - L.B. White Guardian AW060 Owner's Manual And Instructions

Guardian Agricultural Animal Confinement Building Heaters
Air Diverter Installation
Instructions
(Must be ordered separately)
(Appearance of the outlet on heater may
vary from model to model.)
1. Air diverters can be installed in the brood heater
outlet to provide direction to the heated air as it
exits the brood heater. Refer to Fig. 1. Air diverters
can be installed to direct the air in either two 45
degree paths or in one 45 degree direction.
2. The air diverters may require hand forming prior
to installation. Make 90 degree bends utilizing the
perforations provided. The diverter halves should
then have the shape as shown in Fig. 1.
3. The air diverter's tabs on each half will pop into
the blower outlet between the inside of the case
assembly and the blower housing outlet. If the
notched tabs do not pop into the blower outlet,
loosen the blower outlet screws. Doing this
provides a gap into which you can insert the tabs.
Retighten the screws after installation.
FIG. 1
NOTCHES IN MOUNTING TABS
TABS
DIVERTER
HALVES
Alternative Air Diverter Arrangements

Hanging Instructions

(Must be ordered separately)
1. Assemble according to Fig.2 and tighten all
2. Be sure brood heater is securely fastened and is
3. See Fig. 3 for typical indoor installation. In any
FIG. 2
EYEBOLT
FLAT WASHER
OUTLET
SCREWS
FIG. 3
NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF
FORMED
OUTLET GUARD
Owner's Manual • Guardian
eyebolts securely.
hanging level. (Check crosswise and lengthwise
using a level.)
animal confinement building, consideration must
be given to making sure the brood heater is
located away from the livestock so that livestock
cannot knock the heater, tear it loose from its
mounting, or damage the heater or its gas supply
line in any way. Make sure you observe and obey
minimum clearance distances to combustible
materials as stated in the specification section
of this owner's manual and on the brood heater
dataplate.
NUT
CAGE NUT
CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS,
THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT
LINE NO SMALLER THAN VENT OPENING.
VENT OF REGULATOR MUST
POINT DOWN AND REGULATOR
MUST BE VENTED OUTDOORS
OPTIONAL INDOOR
REGULATOR
MOUNTING LOCATION
GAS HOSE
THERMOSTAT
CORD
BROOD
HEATER
YOKE
0.3 m
THERMOSTAT
11
CHAIN
CASE TOP
MANUAL SHUT-OFF VALVE
CAN BE INSTALLED BEFORE
THE REGULATOR, UNDER
THE EAVE OF THE BUILDING,
OR AFTER THE REGULATOR
INSIDE THE BUILDING.
BLACK PIPE
THROUGH WALL
VENT LINE
WALL OUTLET
POWER CORD
SEDIMENT
TRAP
0.3 m