On And Off; Lcd Display; Usb Connection; Wireless (Wi-Fi) Connection - Magtek DynaPro Go Quick Installation Manual

On and Off

To power on the device: Press and hold the Power button for one second. Upon powering up, it will
display the "Welcome" screen and the current device status.
To power off the device: Press and hold the Power button for seven seconds, or press the Power
button for two seconds to display a "Power Off?" screen with a Yes / No selection above the left and
right function keys. To power off, press the function key below Yes. To cancel powering off and return
to the Welcome screen, either wait 10 seconds or press the function key below No. While the device
is powering off, the display shows "Powering off..." for three seconds before the display goes blank.

LCD Display

The device's LCD display uses a backlight and can be configured to either remain at a constant user
selected brightness level (Manual mode) or adapt its brightness to ambient lighting based on the de-
vice's light sensor (Auto mode). The factory default of the device is Manual mode at 75% brightness.
To change the LCD display backlight mode, press Left Function key 5, 2, 2, Right Function key to
open the LCD Brightness Config screen. To exit without saving changes, press the Cancel key or wait
10 seconds for the device to return to the Welcome screen.

USB Connection

To connect DynaPro Go to a host computer or charger using the Micro USB port, follow these steps:
•
Connect the small end of the USB cable to DynaPro Go as shown in Figure 3.
•
Connect the large end of the USB cable to the charger or to the host computer's USB port.
As soon as DynaPro Go starts receiving power through USB, it will automatically power on. If DynaPro
Go is not automatically recognized you may need to unplug and plug it in again.

Wireless (Wi-Fi) connection

•
Make sure the wireless access point, network, device, and host are set up properly and
tested. Check IP address registration on DHCP server, check wireless MAC addresses as
listed devices, and check firewalls for communication. Provide the wireless access point SSID
and passcode to the advanced operator who will configure the devices.
•
Power on the device and make sure the device is configured to use the 802.11 wireless
connection. DynaPro Go supports multiple connection types, but only one interface can
be active at a time. To change the active connection, on the Welcome screen, press Left
Function Key 4 5 6 Right Function Key to show a confirmation screen to begin using the
currently inactive connection type.
•
Make sure the device is connected to the wireless network by checking the status icons. See
Installation and Operation Manual for complete details.

Bluetooth LE

•
To connect DynaPro Go to a host via the Bluetooth LE connection, follow these steps:
•
Make sure the host supports Bluetooth LE Secure Connections.
•
Install host software for DynaPro Go and power on the device.
•
Check DynaPro Go Bluetooth LE active connection.
•
Press Left Function Key 1 2 3 Right Function Key to enable pairing requests.
•
Scan for Bluetooth devices on host and select.
•
Host and Device show 6-digit matching passcode.
•
Accept pairing on device and host.
•
Check pairing by checking the device's status icons.
•
Check the installation and Operation Manual for further details and troubleshooting.
Registered to ISO 9001:2015 © Copyright 2019 MagTek, Inc. PN D998200135 rev rev 60 3/19