Table of Contents
Advertisement
280/407
Mounting and installation
9.2
KSM
9.2.1
Required Steps to Follow
Preparations for Mounting
If the Optional Holding Brake is
Mounting KSM
Mounting for Easy Servicing
Notes on Mounting
Bosch Rexroth AG R911335703_Edition 04
Make the following preparations for mounting:
1. Procure tools, auxiliary materials, measuring and test equipment.
2. Check all components for visible damage. Defective components
mustn't be mounted.
3. Ensure that dimensions and tolerances on the installation side are
suitable for motor attachment (for details, see dimensional drawing).
4. Check whether all components, mounting surfaces and threads are
clean.
5. Ensure that mounting can be done in a dry and dust-free environment.
6. Ensure that the holder for the motor flange is without burrs.
7. Remove the protective sleeve of the motor shaft and keep it for further
use.
Check whether the motor holding brake attains the holding torque specified in
Used
the data sheet. If the holding brake does not attain the specified holding
torque, check the functioning of the holding brake (see
Brake – Commissioning and Maintenance Instructions " on page
To allow trouble-free servicing, make sure that the following aspects are
fulfilled after you have mounted KSM:
●
Connection points X37, X38 and X141 are easily accessible
●
Connection points X108 and X109 are easily accessible
To allow easy and quick drive diagnostics, the terminal connector of the
communication cable should be extended to a directly accessible point
●
Address selector switches are easily accessible
●
Diagnostic LED H14 is visible
●
Avoid jamming or getting stuck of the centering collar on the motor side.
●
Avoid damage to the insertion fitting on the installation side.
●
Check the stability and precision of the connection before you proceed.
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
chapter "Holding
362).
Advertisement
Table of Contents
