2.5
Checking Operations
Control the vision sensor using the programmable controller and check the operations.
Make the vision sensor online
Turn on the programmable controller online command (M0) and shift the vision sensor from the discrete online status to the
online status.
Set the trigger to the vision sensor
Turn on the trigger command (M1) of the programmable controller and trigger it to the vision sensor.
Check inspection results
Pattern_1 PASS (M10) turns on if the inspection subject matches the model set in Pattern_1, and Pattern_1 FAIL (M11) turns
on if the inspection subject does not match.
Open [Online][Monitor][Device/Buffer Memory Batch Monitor] in GX Works3 to display devices.
2 I/O CONNECTION
44
2.5 Checking Operations
Input "M0" in [Device Name].
Check M10 and M11.