Mitsubishi Electric MELSENSOR VS20 Connection Manual page 28

■Device assignment to be used control bit block
Classification Device
Control bit block D1000.0
D1000.1
D1000.2
D1000.3
D1000.4
D1000.5
D1000.6
D1000.7
D1000.8
D1000.9
D1000.A
D1000.B
D1000.C
D1000.D
D1000.E
D1000.F
D1001.0
D1001.1
D1001.2
D1001.3
D1001.4
D1001.5
D1001.6
D1001.7
D1001.8
D1001.9
D1001.A
D1001.B
D1001.C
D1001.D
D1001.E
D1001.F
1 THE SLMP SCANNER CONNECTION
26
1.7 Contents in Data Blocks
Control details (Application)
Network Trigger Enable
Trigger
Buffer Result Enable
Inspection Result ON Acknowledgment
Job Load Trigger
Reserved
SetOffline
Reserved
Set User Data
Send Native Mode Command
Clear Error
Clear Image Complete Signal
Reserved
Soft Event 0 Trigger
Soft Event 1 Trigger
Soft Event 2 Trigger
Soft Event 3 Trigger
Soft Event 4 Trigger
Soft Event 5 Trigger
Soft Event 6 Trigger
Soft Event 7 Trigger
Supplement
The trigger is enabled by turning on this "trigger" bit and
is disabled by clearing this bit.
The following conditions need to be satisfied to enable
the trigger.
• The vision sensor is online when the Network Trigger
Enable bit is on.
• In the setting of In-Sight Explorer, "Industrial Ethernet"
is set for the [Trigger] parameter.
Store an ID of the job to be loaded to the Job Load ID of
the input word block and turn it on.
The vision sensor goes offline when this bit is turned on.
This bit turns offon when the user data of the input
word block is updated.
The error code of the output word block is cleared when
this bit turns ON.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.
It cannot be used with this model.