Thank You; Retail Packing List; Rails; Rail Screws (In The Bag Labeled "Rail") - American Megatrends StorTrends 1100-P User Manual

Thank You

Thank you for purchasing the StorTrends® 1100 storage appliance. Please take a few
minutes to review this easy set up guide before beginning the installation process. If you
require a further explanation of any item covered in this guide, please refer to the
installation instructions on your CD.

Retail Packing List

You should have received the following:
•
An 1100 Chassis
•
One Power Cord
•
Rails (See the Rails subsection for an expanded list)
•
Rail Screws (See the Rail Screws subsection for an expanded list)
•
Software Envelope (See the Software Envelope subsection for an expanded list)
Note:
Your StorTrends® 1100 may or may not ship with everything listed in the Retail Packing
List. Contact your AMI authorized reseller to find out what is shipped with your
StorTrends® 1100 storage appliance if the contents do not match the ones listed in this
document.

Rails

Part
Labeled: 01-01-
813815-XXA
Labeled: 01-01-
813820-XXA
No number stamped
on it. It is considered
part of the 01-01-
813820-XXA part.
Labeled: 01-01-
813811-XXA

Rail Screws (in the bag labeled "Rail")

Screw
Qty Description
2 Rear Inner Chassis Rails 320 mm long (12.625 inches long).
Use 2 Flat head M4 screws to attach these to the 1100 chassis.
2 Rack Rails (Back Part) 305 mm long (12 inches long). Slides
into the Rack Rails (Front Part).
2 Rack Rails (Front Part) 617 mm long (24.313 inches long). The
Rack Rails (Back Part) slides into this, creating an adjustable
Rack Rail to accommodate Rack Enclosures between 64.77 cm
(25.5 inches) to 85.09 cm (33.5 inches) deep. Meaning that the
Rack Rails can be extended from 64.77 cm (25.5 inches) to
85.09 cm (33.5 inches).
2 Rack Rail front brackets 58 mm (2.25 inches long). These can
be attached to the Rack Rails (Front Part) using 2 Round head
M4 x 4 mm screws each. If you are securing the rails using your
own mounting screws, you do not need to use this bracket.
Qty Description
Flat head M4 x 4 mm [0.157]. Used to secure the Rear Inner Chassis
4
Rails to the 1100 Chassis.
12 Round head M4 x 4 mm [0.157]. Used primarily to secure the Rack
Rail front brackets to the Rack Rails. You only need a total of 4.
Flat head M5 x 12 mm [0.472]. Used in conjunction with the
8
supplied Washer to secure the Rack Rails to your Rack Enclosure.
8 Washer for M5. Use with the Flat head M5 screw when you secure
the Rack Rails to your Rack Enclosure.
Preface vii