Keyboard Wake-Up; Keyboard Wake-Up Jumper Settings (Jpwake); Glan2 Enable/Disable; Glan2 Enable/Disable Jumper Settings (Jpl2) - American Megatrends StorTrends 1100-P User Manual

Keyboard Wake-Up

The JPWAKE jumper is used to allow the system to be woken up by depressing a key on
the keyboard from an S1 or S3 state in Windows OS. See the table below for jumper
settings. Your power supply must meet ATX specification 2.01 or higher and supply 720
mA of standby power to use this feature.

Keyboard Wake-Up Jumper Settings (JPWAKE)

Jumper Position
1-2
2-3

GLAN2 Enable/Disable

Change the setting of jumper JPL2 to enable or disable the onboard GLAN2 port on the
motherboard. See the table below for jumper settings. The default setting is Enabled. (For
LAN1, please change the setting in the BIOS.)

GLAN2 Enable/Disable Jumper Settings (JPL2)

Jumper Position
Pins 1-2
Pins 2-3

Keylock Enable/Disable

The Keylock header is located at J36. Close the jumper to enable the Keylock function
and leave the jumper open (off) to disable it. The default setting is open. See the table
below for jumper settings.

Keylock Enable/Disable Jumper Settings (J36)

Jumper Position
On
Off

VGA Enable/Disable

J33 allows you to enable or disable the VGA port. The default position enabled. See the
table below for jumper settings.

VGA Enable/Disable Jumper Settings (J33)

Jumper Position
1-2
2-3
40 StorTrends® 1100 User's Guide
Definition
Disabled
Enabled
Definition
Enabled
Disabled
Definition
Enabled
Disabled
Definition
Enabled
Disabled