I/O Ports; Figure 5-2. I/O Port Locations; Installing Processors; Processor Support - American Megatrends StorTrends 1100-P User Manual

I/O Ports

The I/O ports are color coded in conformance with the PC 99 specification. See Figure 5-
2 below for the colors and locations of the various I/O ports.

Figure 5-2. I/O Port Locations

Mouse (Green)
Keyboard
(Purple)
Note: The COM2 port is a header on the motherboard, located near the ATX power connector.

Installing Processors

Avoid placing direct pressure to the top of the processor package. Always remove the
power cord first before adding, removing or changing any hardware components.

Processor Support

The StorTrends 1100 motherboard has a single 478-pin microPGA socket, which
supports Intel Pentium 4 processors on .013 micron process.

Processor Installation

Step
1
2
3
4
24 StorTrends® 1100 User's Guide
Parallel Port (Burgundy)
USB 0/1 Ports COM1 Port (Turquoise)
Description
Lift the lever on the CPU socket.
Install the CPU in the socket. Make sure that Pin 1 of the CPU is seated
on Pin 1 of the socket (both corners are marked with a triangle).
Press the lever down until you hear it *click* into the locked position.
Apply the proper amount of thermal compound to the CPU die. Place the
heatsink on top of the CPU aligning its holes with those on the retention
mechanism. Screw in two diagonal screws (For example, the #1 and #2
screws) until just snug, then do the same with the remaining two screws.
Finish by fully tightening all four screws (see Figure 5-4 on next page).
VGA Port (Blue) GLAN1 GLAN2