Chassis Illustrations; Figure 6-2. Chassis Rear View; Figure 6-1. Chassis Front View; Control Panel - American Megatrends StorTrends 1100-P User Manual

American megatrends stortrends 1100-p: user guide

Hide thumbs Also See for StorTrends 1100-P:

Table of Contents

Chassis Illustrations

The control panel (located on the front of the chassis) must be connected to the JF1

connector on the motherboard to provide you with system control buttons and status

indicators. These wires have been bundled together in a ribbon cable to simplify the

connection. Connect the cable from JF1 on the motherboard to JP4 on the Control Panel

PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both JF1 and JP4.

Pull all excess cabling out of the airflow path. The LEDs inform you of system status.

See Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1 can

be found in Chapter 5.

Three 4-cm high-performance fans provide the cooling for the StorTrends 5013CMT.

The chassis includes air seals under the fans and at the chassis cross section, which

separates the drive bay area from the motherboard area of the chassis to promote better

airflow. It is highly important that the air seal is properly installed and making a good

seal in order for the cooling air to circulate properly through the chassis.

The fans run at a full 100% rpm. If a fan fails, you will need to have it replaced with the

same type. Contact your vendor or American Megatrends for information on replacement

fans.

StorTrends® 1100 User's Guide

Table of Contents

Stortrends 1100