Rack Mounting - American Dynamics VideoEdge Installation And User Manual

Warnings
To Reduce Risk of electric shock, do not remove cover. no user serviceable parts inside. refer servicing to
qualified service personnel.
Do not expose this appliance to rain or moisture.
Do not install this product in hazardous areas where highly combustible or explosive products are stored or
used.
The lightning flash/arrowhead symbol, within an equilateral triangle, alerts the user to the presence of a shock
hazard within the product's enclosure.
Underwriters Laboratories Inc. ("UL") has not tested the performance or reliability of the security or signaling aspects
of this product. UL has only tested for fire, shock or casualty hazards as outlined in the UL's Standard for Safety UL
60950-1. UL Certification does not cover the performance or reliability of the security or signaling aspects of
this product. UL makes no representations, warranties or certifications whatsoever regarding the
performance or reliability of any security or signaling related functions of this product.
Note to Camera System Installer - This reminder is provided to call the camera systems installer's attention to
Section 820.93 of the National Electrical Code, ANSI/NFPA 70: 2005, which provide guidelines for proper grounding
and, in particular, specify that the coaxial cable shield shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.
Note to Installer - POE networks that are connected to IP Encoders should not be routed to the exterior or outside of
the installed plant location.
This equipment has been tested and found to comply with the limits for a Class "A" digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at their own expense.
Changes or modifications not expressly approved by Sensormatic the party responsible for FCC compliance, could
void the user's authority to operate the equipment.
This product was FCC verified under test conditions that included the use of shielded I/O cables and connectors
between system components. To be in compliance with FCC regulations, the user must use shielded cables and
connectors for all except power and alarm cables.
This class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Rack Mounting

Consult with the supplier of your equipment rack for adequate rack mounting means, with proper
consideration for the weight of this product.
Consult with the manufacturer of your rack regarding the proper hardware and procedure of mounting this
product in a safe and useable fashion
Avoid uneven loading or mechanical instability when rack-mounting units.
Make sure that units are installed to get enough air flow for safe operation.
The maximum temperature for rack-mounted units is 50° C.
Avoid uneven loading or mechanical instability when rack-mounting units.
Check product label for power supply requirements to assure that no overloading of supply circuits or
overcurrent protection occurs.
Mains grounding must be reliable and uncompromised by any connections.
iii