Led Status Descriptions; Serial Connectors; Terminal Block Connector - American Dynamics VideoEdge Installation And User Manual

Technical specifications

LED status descriptions

Power LED
• On with repeating slow short flashes off – Normal operation
• Rapidly flashing – Invalid stored configuration / operating on factory defaults
Client LED
• On – operating normally with 1 or more clients connected
• Off – operating normally with no clients connected
• Flashing rapidly – network not ready, no IP address assigned
Video/Alarm LED
• Not used at this release to indicate alarm conditions
Note
Power and Video/Alarm LEDs rapidly flashing together indicates a firmware or configuration
update is in progress.
Note
During the power up process all three LEDs may flash on or off however if all three LEDs are
flashing together followed by a short delay and the flash sequence repeated, this indicates a
Power On Self Test (POST) error. The number of rapid flashes indicates the actual error code.
Ethernet Port LEDs
• Green LED
•On / flashing – traffic on the network
• Yellow (with green LED on or flashing)
•On – full duplex connection
•Off – half duplex connection
• Both Green and yellow LEDs off or flashing every few seconds – no valid network signal

Serial connectors

Terminal block connector

5-2
Figure 5-3 Terminal block pin assignments
Installation and User Guide