Advertisement
Attention
•
This installation guide is subject to change without notice, please contact us to request the most
updated version of this installation guide.
•
This is a general installation guideline, actual installation may vary. Consult a professional if
necessary.
•
Product drawings in this installation guide is for illustration purpose only. Actual product may vary
depends on model.
•
Always take extra precautions and wear appropriate safety equipment when installing this product.
•
Proper water pressure needs to be maintained to prevent possible scalding.
•
Stainless steel shower panels are handmade and assembled. Product dimensions may vary
slightly, always measure the actual product before installation.
You may also need the following tools
1. Thread Sealant Tape, (PTFE Tape)
2. Silicon Sealant
3. Phillips Screw Driver
4. Drill with ¼" Drill bit
Before You Begin
•
Read and understand this instructions completely before installation.
•
Unpack and inspect the shower panel from the package for shipping damage and make sure all
parts are included with the shower panel.
•
Keep the product in its package until you are ready to install.
•
Read and understand this installation guide completely.
•
Make sure the installation site is clean and free of dust and debris.
•
Please make sure the water supply is shut off to the installation area. If necessary, shut off the
water to the entire house.
•
Turn on the water at a bathroom faucet in the house to relieve the pressure in the plumbing
system.
Before installation begins, measure the distance
between the existing shower head and the control
to make sure there is sufficient space to fit the
shower panel. The distance needs to be 34" - 42"
to fit the shower panel.
Decor Star
5. Pencil or Marker
6. Level
7. Hammer
34" - 42"
3
PL-019-SS Rev. A1
122015
Advertisement
