Advertisement
Installation (cont.)
A
B
C
D
Decor Star
7. Hang the unit on the wall. Make sure the unit is
seated properly. Apply silicon sealant on both sides of
the shower panel to complete the installation. (NOTE:
do not seal the bottom of the panel, this will allow any
possible future leaks to drain out the panel)
8. Disassemble the water supply hose assembly by
loosen the compression nut (C),remove compression
ring (B) and pull out the elbow connetor (A)
9. Measure the length needed for the main water sup-
ply hoses. Trim off the excess PVC tubing.
9
PL-019-SS Rev. A1
122015
Advertisement
