American Dynamics DV16000 Installation And Operating Instructions Manual page 74

®
Intellex
74
Schedule Setup
Digital Video Management System Installation and Operating Instructions
exterior cameras recording from day to night or interior
cameras recording areas with lighting turned on or off. To
ensure that useful video is recorded or filtered, nominal
lighting in the area is required. You should adjust the filter
sensitivity for the lowest lighting condition that applies
(e.g., low sensitivity for low lighting), and then test the
filter to ensure its proper activation. More lighting in the
area will allow higher sensitivity settings to be safely
used.
NOTE: You can configure one or more motion detection target
areas at a time.
1. Set the Sensitivity: 1 to 100.
2. Move the mouse pointer to the image area. The mouse
pointer changes to
3. Draw the boundaries of the target area.
NOTE: The target area must be enclosed to activate the filter.
a. Move the mouse pointer to the first corner of the target
area and click the mouse button.
NOTE: To erase the last endpoint, double-click the right mouse
button.
b. Move the mouse pointer to the next corner of the target
area. The unit draws a line as the pointer moves.
NOTE: The pointer changes to
location.
c. Click the mouse button to lock this boundary and start a
new one.
d. Repeat these steps until you are ready to enclose the
target area.
e. Use one of the following methods to enclose the target
area:
Set at least three endpoints. Then hold the mouse pointer
over the last endpoint and double-click the button. The
boundary lines disappear and the target area is defined by a
semitransparent grid.
.
if it is dragged to an invalid
MORE>>>