American Dynamics DV16000 Installation And Operating Instructions Manual page 17

®
Intellex Digital Video Management System Installation and Operating Instructions
SCSI-3
Network
Installing the Intellex Unit
NOTE: For the S-VID OUT connector to be enabled, it must be
connected to a properly terminated device when the unit
is powered up.
NOTE: The Monitor and S-VID OUT connectors operate at a
refresh rate of 60Hz (50 Hz PAL) when the S-VID OUT
connector is in use.
To connect an optional television:
1. Disconnect both ribbon cables from connectors 23 and 25 on
the rear panel (see
2. Connect one of these outputs to the video input of an
optional television or VCR.
3. Reconnect both ribbon cables to connectors 23 and 25 on the
rear panel.
NOTE: Even though an external SCSI terminator is not required
on this unit, it may be required on the optional data
storage device.
To connect an optional storage device:
1. Disconnect both ribbon cables from connectors 23 and 25 on
the rear panel (see
2. Connect the optional data storage device to connector 20 on
the rear panel.
3. Reconnect both ribbon cables to connectors 23 and 25 on the
rear panel.
Refer to the External Data Storage Installation instructions for more
information. (Contact your dealer or Sensormatic for this
document.)
NOTE: Do NOT connect the Intellex unit to a network unless you
also install the Network Client on the network.
NOTE: We recommend the use of shielded twisted-pair cable for
network operation.
Connect the cable from the local area network to Connector 15
(Network). Use Category 5 twisted-pair Ethernet cable (CAT 5
TPE). Refer to the
information.
Rear Panel).
Rear Panel).
Network Client instructions for more
17
MORE>>>