Canvas HANOVER 064-4016-8 Assembly Instructions Manual page 5

overheats or abnormal heating occurs,
the thermostat protective device cuts
off the power supply to avoid fireplace
damage and reduce the risk of fire.
9. Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock,
or injury to persons.
10. If possible, always unplug this
appliance when not in use.
11. Do not operate any heater with
a damaged cord or plug or after
the heater malfunctions.
12. Do not operate any heater if it has
been dropped or damaged in any
manner. Disconnect power at service
panel and have heater inspected by a
reputable electrician before reusing.
13. Any repairs to this fireplace should
be carried out by a qualified service
person.
SAVE THESE INSTRUCTIONS
A 15 A, 120 V, 60 Hz circuit with a properly grounded
outlet is required. Preferably, the fireplace should be on a
dedicated circuit as other appliances on the same circuit
may cause the circuit breaker to trip or the fuse to blow
when the heater is in operation. The unit comes standard
with a 6' (1.8 m) three-wire cord, exiting from the rear
of the fireplace. Do not exceed the current rating of
the current tap. Always plug heaters directly into a wall
outlet/receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
• This heater is for use on a 120 V outlet. The cord
has a plug as shown. See illustration for grounding
instructions. An adaptor as shown in Fig. B is available
for connecting three-blade grounding type plugs to two-slot receptacles. The green
grounding plug extending from the adaptor must be connected to a permanent ground
such as a properly grounded outlet box. The adaptor should not be used if a three-slot
grounded receptacle is available.
NOTE
:
The use of grounding adaptors is banned in certain jurisdictions in Canada due
to safety concerns. The use of grounding adaptors for use with two-slot receptacles is
unsafe and they should only be installed by a certified electrician. Check with local laws
to ensure compliance with legal requirements.
14. Under no circumstances should this
fireplace be modified. Parts having
to be removed for servicing must
be replaced prior to operating this
fireplace again.
15. Only connect to properly grounded
outlets.
16. This appliance, when installed,
must be electrically grounded in
accordance with local codes, with
the current CSA C22.2 Canadian
Electrical Code or follow the National
Electrical Code, ANSI/NFPA N0.70.
17. The heater must not be located
immediately below a wall outlet/
receptacle.
18. Do not slide insert on top of wood
to avoid scratching wood surface.
19. Do not place any objects on top of
insert and top air intake vents as this
will cause unit to overheat and can
cause a fire.
Grounding Pin
Cover of Grounded Outlet Box
Adaptor
Grounding Pin
Metal Screw
Cover of Grounded Outlet Box
HANOVER MEDIA FIREPLACE
A
B
5