Jtag Connector (J8); Figure 20 - 14-Pin Jtag Connector (J8) - pandaboard OMAP 4 Series System Reference Manual

2.19
The PandaBoard provides a 14-pin 0.1" (2.54mm) pitch through-hole connector at J8 as shown in Figure
20 below. In the figure below, pin 1 is the lower left pin and pin 2 is directly above it. Odd number pins
are on the bottom side of the connector, and even numbered pins are along the top. Pin 6 is removed to
comply with the keying on the JTAG pods.
See Table 13 for a description of the pins their connectivity to OMAP4430, and their function on this
connector.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
TM
OMAP
Reference Manual

JTAG Connector (J8)

Figure 20 – 14-pin JTAG Connector (J8)
4 PandaBoard System
Revision 0.4
September 22, 2010
DOC-21010
Page 47 of 83