Advertisement
NOTE: Use a level to
make sure rim is level side
to side before tightening
nuts
OPTIONAL: If desired, you
can level the rim front to
back using shim washers
placed between the rim
spacer (W) and Rim (II).
Using (2) Rim Plate Screws (FF) attach the Metal Rim Plate (GG) to the rim (II). The
Metal Rim Plate (GG) covers the springs in the Rim (II) as shown below.
Make sure all
Make sure all nuts on the system have been tightened.
NOTE: Do not over tighten. If unit is excessively difficult to crank up
and down the 16mm Lock Nut (O) that secures the Main Extension
Arm (B) and Vertical Post (A) is probably too tight.
If not already done, remove the spring assist spacers. Cut off the spring assist spacer
that is attached to the Spring-Assist Cartridge(s) (E) using a box cutter.
Replace Net
produnkhoops.com/video/rim_net_replacement.html
nuts on the
20
Advertisement
