Advertisement
3) Anchor Assembly
Twist (6) nuts (L) to the bottom of threads on
(6) J-bolts (K). Place these J-bolts through the
holes on the black anchor plate (N) and install
(6) nuts (L) and tighten. The bottom of the J-
bolts should be positioned as shown.
NOTE: There will be (12) flat washers (Z),
(6) lock washers (O), and (6) hex nuts (BB)
left over after the Anchor Assembly. These
will be used on the Assembly Day. You can
set them to the side for now.
4) Pouring Concrete and Setting Pier Kit
For this step you will need: level, broomstick and tape measure. The 48" x 24" anchor
footing will require a little over a 1/2 yard of 3000 psi concrete (20-25 80 pound sacks
of premix concrete). More will be needed if you dig a larger hole.
NOTE: Make certain that you have enough concrete to
finish the job. Allowing a portion to dry while you purchase
more concrete will weaken the footing.
Mixing and Pouring Concrete
produnkhoops.com/video/mix_concrete.html
Mix (20-25) 80 lbs. bags of concrete in wheel
barrow or cement mixer and pour in pre-dug
hole about half full. Agitate concrete with
shovel or broomstick to ensure proper fill.
Place (6) Pieces of rebar (M) (included) in the
middle of the hole about 6 inches apart to
create a rectangle in the middle of the hole.
All 6 pieces of rebar need to overlap the J-
bolts at least 6 inches.
NOTE: Mix concrete to
manufacture specifications.
Assembling Anchor
produnkhoops.com/video/assemble_anchor.html
11
Advertisement
