L.B. White Premier TS040 Owner's Manual And Instructions page 12

12
Premier Ductable Heater
Thermostat Bracket, Hose
Hanger, Regulator
Bracket
1. Thermostat Storage Bracket
a. Thread the four 3/8 in. hex head screws to the four
holes on the back of the heater case. DO NOT
TIGHTEN the screws at this time. See Fig. 2, Premier
170 shown.
b. Slide the four keyholes of the thermostat bracket
mounting flanges over the four screws.Push the
bracket downward, hold in place. Tighten the screws
securely with a 1/4 in. driver through the bracket's
access holes. See Fig. 2. Premier 170 shown.
FIG. 2
Rivnuts
Regulator
Bracket
c. Store the thermostat within the bracket when not in
use.
2. Hose Hanger
a. Align wire hose hanger to rivnuts on back of heater.
b. Mount the hanger using the 1/4-20 x 3/4 in. bolts and
1/4 in. flat washers. Tighten securely. See Fig. 2,
Premier 170 shown.
3. Regulator Storage Bracket (Premier 170)
a. Align the regulator storage bracket to the two 1/8 in.
diameter holes on the back of the heater case.
b. Mount the storage bracket to the case using the two
3/8 in. hex screws. Tighten securely.
Owner's Manual • Premier Ductable Heater
Hose Hanger
Bolts & Flat
Washers
Thermostat
Storage Bracket
3/8 in. Screws
Thermostat
If thermostat is not needed or required, select manual
setting on thermostat switch. See Fig. 3.
FIG. 3
Thermostat
Switch
If a thermostat is required, remove the thermostat outlet
cover and plug the thermostat cord into the thermostat
outlet receptacle. Use ONLY L.B. White thermostat cord
with plug. Do not use an inline thermostat plug when plug-
ging to thermostat outlet receptacle. Select the thermostat
setting on the switch. See Fig. 4.
FIG. 4
Thermostat
Receptacle
Thermostat
Cord
* ALWAYS cover the thermostat outlet when not in use.
* DO NOT plug an appliance into the thermostat outlet.
* DO NOT plug the thermostat cord into a power
receptacle.