Use Of The Device; Device Configuration - Bticino Sfera User And Installation Manual

Sfera Proximity Reader
User and installation manual

Use of the device

The BTicino Sfera Proximity Reader enables residents to open a door lock using univocal codes,
read by appropriate badges.
The device consists of an antenna used for reading the badge (transponder), and luminous
and sound indicators for the control of the correct storage of the codes inside the badge. The
transmission of the codes takes place when the badge is placed near the proximity reader.

Device configuration

The configuration can be performed in two ways:
- using thel TiSferaDesign software
- following specific procedures using the
To save the manager master codes remove the front cover and press the programming
pushbutton indicated in the legend. Once the badges have been saved in the reader, opening of
the door lock will be possible.
Four types of badges may be programmed:
MANAGER MASTER Badge providing access to the programming of other codes.
It can only be used for programming, not for access.
APARTMENT MASTER Once the apartment badge has been defined, this can be used to program
the badges of the resident of that apartment. It can only be used for programming, not for access.
PASSEPARTOUT It can be used to open the door lock the entrance panel is associated to.
It's not linked with any apartments.
It can only be used for access, not for programming..
RESIDENTS It can be used to open the door lock the entrance panel is associated to.
It's linked to an apartment of the system.
It can only be used for access, not for programming.
When switched on for the first time, the Proximity Reader has no preset badges
reader
12
M= 00 managing
residents using the manager
master.
M= 01 managing
residents using the
apartment master