Cleaning - After Each Use; Cleaning - Monthly - Dualit dcm2x Instruction Manual & Guarantee

Hide thumbs Also See for dcm2x:
Table of Contents

Advertisement

CLEANING - AFTER EACH USE

BEFORE CLEANING, MAKE SURE THE MACHINE IS SWITCHED OFF,
UNPLUGGED AND ALLOWED TO COOL. Do not wash any of the plastic
accessories in a dishwasher.
1
THE FILTERS
2
BIN
Turn the filter holder upside
Empty the drip tray regularly.
down over a bin and knock
If the red tray full indicator is
out the grounds. Be careful
visable, empty immediately.
not to throw away the cup
Remove the non-slip mat
filter.
and rinse after each use.
4
5
WIPE THE WAND
After each use, clean the
IMPORTANT NOTICE:
wand with a damp cloth.
After each use, flush the
There should be no milk
steam wand by dispensing
residue visible.
water or steam, this will
remove any milk residue from
inside the steam wand.
DRIP TRAY
3
THE NOZZLE
Pull the froth nozzle off the
wand and wash under running
water to remove any milk
residue.
6
FLUSH THE
EMPTY WATER
STEAM WAND
Empty and rinse out after
each session and refill with
fresh water just before you
make your next round of
espresso.
16

CLEANING - MONTHLY

BEFORE CLEANING, ENSURE THE MACHINE IS SWITCHED OFF,
UNPLUGGED AND ALLOWED TO COOL. USE DUALIT CAPSULES OR ESE
PODS TO REDUCE FREQUENCY OF CLEANING.
1
WIPE BREWHEAD
2
Wipe the entire
Using a screwdriver and
brewhead area and
hammer, gently tap the
ensure it is completely
screw to dislodge any dried
free of coffee grounds.
coffee. Then unscrew
Fine coffee grounds can block
anti-clockwise.
the showerhead.
4
5
UNBLOCK FILTER
Filters often get blocked
Locate the measuring spoon
with prolonged use. To
onto the steam wand nut.
unblock, use the filter pin
Unscrew anti-clockwise and
and push through the central
remove.
hole on both sides of the
filter to unblock.
UNSCREW
3
CLEAN BREWHEAD
Thoroughly clean the
showerhead and gasket to
remove any coffee grounds.
Use the filter pin to unblock
or rinse in suds.
6
UNSCREW
CLEAN THE
STEAM WAND
Use the steam pin to
remove dried milk from
inside the steam wand.
Use the measuring spoon
to place the nut back on
the steam wand. Screw
clockwise until tight.
17

Advertisement

Table of Contents
loading

Table of Contents