Cleaning After Each Use; Cleaning & Descaling - Dualit CINO Instruction Manual & Guarantee

CLEANING AFTER EACH USE

It is important to clean the DUALIT CINO™ after each use. Make
sure the machine is switched off, unplugged and allowed to cool.
1 FLUSH 2 WIPE
Flush the Steam Wand by Thoroughly wipe the Steam
dispensing steam to remove Wand to clean off any milk
any milk residue from inside residue with a damp cloth.
the Steam Wand after each CAUTION: Steam Wand wlll
use. be hot.
CLEAN
4
CAUTION: Allow Drip
Tray to cool down before
emptying. Clean Drip Tray
with warm soapy water
using a non-abrasive pad and
dry. Wipe up any Descaler
overspill.
3 UNPLUG
Unplug the machine, and
allow to cool.
12
CLEANING & DESCALING
The machine has a Descale Counter. The machine will advise you when a descale
is required based on the number of uses.
If the Indicator Light is Amber, machine needs to be descaled immediately.
If the Indicator Light is Red, machine has entered Lock Mode, to prevent use until a descale is performed.
1 CLEAN THE 2 DESCALER
STEAM NOZZLE
Unscrew the Steam Nozzle Purchase Descale Solution
anti-clockwise and use a pin which is suitable for Coffee
to remove dried milk. If too Machines. Ensure the Steam
tight to unscrew, use an 8mm Valve is closed and ensure
spanner. Screw Steam Nozzle the Drip Tray is located
back onto the steam wand, against the front of the
ensuring it is tight. machine.
4 FILL TANK 5 PLACE CONTAINER
Fill the Water Tank with 1
Place Water Tank back into
litre of Descale Solution.
machine. Place a container with
Follow instructions and
a capacity of more than 2 litres
safety precautions on the
on top of the Drip Tray, located
Descaler packaging. If using
under the Steam Wand. Ensure
granular descaler, ensure
Drip Tray is located against the
it is fully dissolved before
front surface of the machine.
switching the machine on.
3 REMOVE
CAUTION: Remove Water
Tank from machine then
remove Water Filter Holder
from Water Tank. Do not
allow Descale Solution to
come in contact with Dualit
Water Filter. Risk of injury or
contamination!
6 INDICATOR LIGHT
Depending on the machine's
status the Indicator Light will
be flashing Green, Amber
or Red whilst warming up.
Once machine is warmed up
the Indicator Light will stop
flashing and remain on.
13