Table of Contents
Advertisement
48
www.aeg.com
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
12.10 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait until
the oven is cold.
Close the oven door to the
first opening position (ap‐
proximately 45° angle).
Hold the door with one hand
on each side and pull it
away from the oven at an
upwards angle. Put the door
with the outer side down on
a soft cloth on a stable sur‐
face.
Hold the door trim (B) on
the top edge of the door at
the two sides and push in‐
wards to release the clip
seal.
Pull the door trim to the
front to remove it.
Hold the door glass panels
on their top edge one by
one and pull them up out of
the guide.
Clean the glass panel with
water and soap. Dry the
glass panel carefully. Do not
clean the glass panels in
the dishwasher.
After cleaning, do the above
steps in the opposite se‐
quence.
Install the smaller panel first, then the larger and the door.
Before you replace the lamp:
Step 1
2
B
Step 2
Disconnect the oven from
the mains.
45°
1
Step 3
Put a cloth on the bottom of
the cavity.
Advertisement
Table of Contents
