Regulus FlowCon B Installation Operation Commissioning

Regulus FlowCon B Installation Operation Commissioning

Pump station

Advertisement

Quick Links

FlowCon B
Operation
Commissioning

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FlowCon B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Regulus FlowCon B

  • Page 1 FlowCon B Installation Operation Commissioning...
  • Page 2 Technical data and operation Installation Mounting the pump station Integration of DeltaSol® B Cotroller Filling and flushing the system Draining the system Emptying the system by a filling pump Commissioning / Working mode Non-return valves Expansion tank connection set Solar pump group enabling to integrate a Controller •...
  • Page 3 Installation 1 - Mounting holes 2 - Manometer 3 - Ball valve with non-return valve and dial thermometer 4 - Ball valve and flowmeter 5 - Full empty valve 6 - Full empty valve 7 - Air separator with manual discharge (only FlowCon BL) Mounting the pump group •...
  • Page 4 ® Integration of the Controller DeltaSol front insulation jacket rear insulation jacket front view rear view • Take off the front insulation jacket, starting from the top (hold the thermometers). • Pull the part with controller recess downwards. • Insert the Controller into the provided recess of the insulation and fix it by the fastening screws (3 x 30) and large washers.
  • Page 5 Draining the system 1. Open both non-return valves in the ball valves (3) by using a wrench 14 for opening halfway the ball valve (see non-return valves). 2. Fit a drain cock at the lowest point of the system. 3. Open all air vents at the collector in order to let air into the system and the collectors to drain.
  • Page 6 Expansion tank connection set The expansion tank connection set consists of a stainless-steel corrugated pipe 0.5m long with cap nuts on both ends, flat gaskets and connection screw joints for solar expansion tank, and a mount strut for connecting an expansion tank.
  • Page 7 Quantity: Tel: Rubber stamp print and signature of the seller: Date: Rubber stamp print and signature of the installer: Regulus spol. s r.o. Tel.: +420 241 765 191 Do Koutů 1897/3 Fax: +420 241 763 976 143 00 Praha 4 e-mail: sales@regulus.cz...

Table of Contents