Start And Stop Manual Recording; Display Remaining Recording Time - PCE Instruments PCE-HT 72 User Manual

9

Start and stop manual recording

To use the manual mode, perform the following procedure:
No. Description
1 First set the meter using the software.
2
After the upload, the display shows "Start Mode" and
3
Now press the
4 This indicates that recording has been started.
To cancel the measurement now, proceed as follows:
No. Description
1 Here you are informed that the recording has started.
2
Now briefly press the
3 The display now shows "MODE" and "STOP".
4
Now press and hold the
5
Normal measurement was resumed and the display shows
Important: When recording is finished, the measuring device must be reconfigured. It is therefore
not possible to resume recording.
10

Display remaining recording time

To view the remaining recording time, briefly press the
time is displayed under "TIME".
Important: This display does not take the battery into account.
key for two seconds to start recording.
key.
key.
© PCE Instruments
9
.
.
key during recording. The remaining