Symptoms - Husqvarna AUTOMOWER 435X AWD Operator's Manual

6.6 Symptoms

If your product does not work as expected, follow the symptoms guide below.
There is a FAQ (Frequently Asked Questions) on www.husqvarna.com which provides more detailed answers to a
number of standard questions. Speak to your local Husqvarna representative if you still cannot find the reason for the
fault.
Symptoms Cause
The product has diffi- The boundary wire is not laid in a long
culty docking. straight line that is far enough out from the
charging station.
The charging station is on a slope.
The product runs at The clock needs to be set.
the wrong time.
The start and stop times for mowing are in-
correct.
The product vibrates. Damaged blades lead to imbalance in the
cutting system.
Too many blades in the same position lead
to imbalance in the cutting system.
Different versions (thickness) of Husqvarna
blades are used.
The product runs, but The product searches for the charging sta-
the blade disc does tion.
not rotate.
The product mows Grass or other foreign object blocks the
for shorter periods blade disc.
than usual between
The battery is spent.
charges.
Both the mowing and The battery is spent.
charging times are
shorter than usual.
The product is The STOP button has been activated.
parked for hours in
the charging station.
Parking mode is activated.
The product is not allowed to operate if the
battery temperature is too high or too low.
52 - Troubleshooting
Action
Check that the charging station has been in-
stalled according to the instructions. Refer to
To install the charging station on page 23
Place the charging station on a surface that
To examine where
is entirely level. Refer to
to put the charging station on page 18 .
Set the clock. Refer to Time & date on page
32 .
Reset the start time and change the
ule settings. Refer to Schedule on page 29 .
Inspect the blades and screws and replace
Replace the
them if necessary. Refer to
blades on page 38 .
Check that only one blade is fitted at each
screw.
Check if the blades are of different versions.
No action. The blade disc does not rotate
when the product is searching for the charg-
ing station.
Remove and clean the blade disc. Refer to
Replace the blades on page 38 .
Replace the battery. Refer to
page 41 .
Replace the battery. Refer to
page 41 .
Make sure that the START button is pushed
down.
Select the operating mode in Automower
®
Access or Automower Connect.
Check that the charging station is placed in
an area with protection from the sun.
1404 - 006 - 05.01.2021
Sched-
Battery on
Battery on
®