Husqvarna AUTOMOWER 435X AWD Operator's Manual page 47

Message Cause
Mower tilted
The product is tilted more than the maximum
angle.
Lifted
A blockage has activated the lift senors and
caused the product to stop.
Collision sensor The product body can not move freely
problem
around its chassis.
Slope too steep
Mower stopped because the slope is too
steep.
Alarm! Mower switch-
The alarm was activated because the prod-
ed off
uct was switched OFF.
Alarm! Mower stop-
The alarm was activated because the prod-
ped
uct was stopped.
Alarm! Mower was
The alarm was activated because the prod-
moved uct was moved.
Alarm! Outside geo- The alarm was activated because the mower
fence
was outside its GeoFence.
Electronic problem Temporary electronic or firmware related is-
sue.
Loop sensor problem
Charging system
problem
Tilt sensor problem
Temporary problem
STOP button prob-
lem
Ultrasonic problem
GPS navigation prob-
lem
Angular sensor prob-
lem
Switch cord problem
Invalid sub-device
combination
Invalid system config-
uration
1404 - 006 - 05.01.2021
Action
Move the product to a flat area.
Remove the product from the blockage. If the
problem remains it requires action by author-
ized service technician.
Make sure that the product body can move
freely around its chassis.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
Change the installation of the boundary wire
to exclude this steep part of the work area.
To examine where to put the boun-
Refer to
dary wire on page 19 .
Adjust the security level in the
Security (Bluetooth
menu, refer to
page 32 .
Adjust the theft protection area (GeoFence)
Automower Connect menu.
in the
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
Troubleshooting - 47
Security
®
only) on