Husqvarna AUTOMOWER 435X AWD Operator's Manual page 31

To set the GPS function
1. Select Installation > Settings > Lawn coverage in
the app.
on/off to disable or enable the GPS
2. Select
function.
Note:
When GPS assisted navigation is enabled
it is used while there is a GPS service. The GPS
assisted navigation is used even if manual settings
have been made. Only when GPS service is not
available, the manual settings are used.
Save .
3. Select
To set the Lawn Coverage function
The Lawn Coverage function is used to guide the
product to remote parts of the work area. If the work
area includes remote parts that are connected with
Lawn Coverage function is useful
narrow passages, the
to to keep a well-cut lawn in all parts of the yard. You
can set a maximum of 5 remote areas where the product
starts to cut the lawn.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
Each area can be enabled or disabled, without having to
enter the settings again.
Settings > Installation > Lawn coverage in
1. Select
the app.
on/off to disable the GPS function to set the
2. Select
Lawn Coverage .
Area 1-5 to activate the area.
3. Select on/off
4. Move the horizontal bar to set which wire the
product will follow. The product can follow
1404 - 006 - 05.01.2021
Boundary wire left , Boundary wire right or one of
the guide wires.
5. Move the horizontal bar to set the distance the
product must follow the wire. The product then
leaves the wire and starts to cut the lawn. Refer to
To measure the distance from the charging station
on page 31 .
6. Move the horizontal bar to set how often the
product goes to each area. At all other times, the
products starts to cut near the charging station.
The percentage is equal to the percentage of the
area in relation to the complete work area.
a) Measure the area.
b) Divide the measured area with the total work
area.
c) Convert the result to percentage.
d) Move the horizontal bar to set the distance
from the charging station.
7. Select
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it leaves the
charging station. If the guide wire is less than 300 m /
980 ft. the product will follow it to the point where the
guide wire is connected to the boundary wire.
To measure the distance from the charging station
1. Put the product in the charging station.
2. Select
the app.
3. Move the horizontal bar to set the distance to the
charging station to maximum.
C
4. Select
5. Follow the instructions in the app to start the test.
6. Push the STOP button when the product is at the
distance you select to measure. The distance
shows in the app.
To do a test of the Lawn Coverage function
1. Put the product in the charging station.
2. Select
B
the app.
3. Select
4. Follow the instructions in the app to start the test.
5. The product will run to the starting point for this
area.
3.12.3.5 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting for
Drive Past Wire function function is 31 cm / 13 in.
the
You can select a distance of 20-50 cm / 10-15 in.
Note:
With the factory setting the product will cut 11
cm / 4.3 in. past the wire.
Save .
Settings > Installation > Lawn coverage in
Test: Area 1-5 setup .
Settings > Installation > Lawn coverage in
Test: Area 1-5 setup .
Installation - 31