Husqvarna AUTOMOWER 435X AWD Operator's Manual page 24

2. Put the charging station in the selected area.
Note:
Do not attach the charging station with the
screws to the ground until the guide wire is
installed. Refer to To install the guide wire on page
24 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
Note:
When the charging station is connected, it
is possible to charge the product. Put the product
in the charging station while the boundary and
guide wires are being laid. Switch on the product to
start charging the product. Refer to
the product on page 34 . Do not continue with any
product settings before the installation is complete.
6. Put the low-voltage cable in the ground with stakes
or bury the cable. Refer to
position with stakes on page 25 or To bury the
boundary wire or the guide wire on page 25 .
7. Connect the wires to the charging station after the
installation of boundary wire and guide wire is
To install the boundary wire on
complete. Refer to
page 24 and To install the guide wire on page
24 .
8. Attach the charging station to the ground with the
supplied screws after the guide wire is installed.
Refer to To install the guide wire on page 24 .
3.5.3 To install the boundary wire
CAUTION:
Do not put remaining wire in
a coil. The coil causes interference with the
product.
1. Put the boundary wire around all of the work area.
Start and complete the installation behind the
charging station.
2. Open the connector and put the boundary wire in
the connector.
24 - Installation
3.
4.
5.
6.
7.
To switch on
8.
9.
3.5.4 To install the guide wire
To put the wire into
1.
2.
3.
4.
5.
6.
7.
8.
Close the connector with a pair of pliers.
Cut the boundary wire 1-2 cm / 0.4-0.8 in. above
each connector.
Put the right end of boundary wire into the channel
with the mark "AR".
Put the left end of boundary wire into the channel
with the mark "AL".
Push the right connector onto the metal pin on the
charging station with the mark "AR".
Push the left connector onto the metal pin on the
charging station with the mark "AL".
Put the cable mark on the left and right boundary
wire. Do not walk on the charging station.
CAUTION:
Twinned cables, or a screw
terminal block that is insulated with
insulation tape are not satisfactory splices.
Soil moisture will cause the wire to oxidize
and after a time result in a broken circuit.
Open the connector and put the wires in the
connector.
Close the connector with a pair of pliers.
Cut the guide wires 1-2 cm / 0.4-0.8 in. above each
connector.
Put the guide wires centrally below the charging
station plate, and push them through the slot in the
charging station tower.
Push the connector onto the metal pin on the
charging station with the mark "G1" or "G2".
Disconnect the charging station from the power
outlet.
Put the cable mark on the guide wires.
Put the end of the guide wires at the eyelet on the
boundary wire.
1404 - 006 - 05.01.2021