Husqvarna AUTOMOWER 435X AWD Operator's Manual page 48

Message Cause
Temporary battery
Temporary battery or firmware related issue.
problem
Battery problem
Battery temperature
The product does not operate if the battery
outside limits temperature is too high or too low.
Faulty mix of batter-
The battery type is incorrect.
ies
Charging system Temporary battery or software related issue
problem
in the product.
The battery type is incorrect.
Charging current too
Wrong or faulty power supply unit.
high
Connectivity problem
Problem with the Automower
ule.
Connectivity settings
The connectivity settings for the Automower
restored
Connect module was restored because of a
fault.
Outside work area
The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product finds it hard to distinguish the
signal from another product installation close
by.
48 - Troubleshooting
Action
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
The product starts to operate again when the
temperature is between the set limits and the
schedule settings let the product to operate.
Make sure that the charging station is put in
an area with protection from the sun.
Only use original batteries that are recom-
mended by the manufacturer.
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
Only use original batteries that are recom-
mended by the manufacturer.
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
®
Connect mod- Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
®
Do a check of the settings and change the
settings if needed.
Make sure that the boundary wire is connec-
ted correctly. Refer to
put the boundary wire on page 19 .
Make sure that the boundary wire has been
laid according to the instructions. Refer to
install the boundary wire on page 24 .
Move the boundary wire and/or make more
islands in the work area to increase the sig-
nal strength.
Put the product in the charging station and
generate a new loop signal. Refer to
ate a New loop signal on page 33 .
To examine where to
To
To cre-
1404 - 006 - 05.01.2021