Husqvarna AUTOMOWER 435X AWD Operator's Manual page 16

Robotic lawn mower
Hide thumbs Also See for AUTOMOWER 435X AWD:
Table of Contents

Advertisement

Use the park mode, refer to
switch off the product when persons, especially
children or animals are in the work area. Refer to
To switch off the product on page 35 . It is
recommended to program the product for use
during hours when the area is free from activity.
Consider that certain animals, e.g. hedgehogs, are
active at night. They can potentially be harmed by
Schedule on page 29 .
the product. Refer to
Do not install the charging station, including any
accessory, at a location that is below, or within 60
cm / 24 in. from, any combustible material. Do not
install the power supply unit in easily flammable
surroundings. In case of malfunction, heating of
the charging station and the power supply may
occur and create a potential risk of fire.
Check that there are no foreign objects such as
stones, branches, tools or toys on the lawn. If the
blades hit foreign objects the blades can be
damaged. Always switch off the product before
clearing a blockage. Inspect the product for
damage before staring the product again. Refer to
To switch off the product on page 35 .
If the product starts to vibrate abnormally. Always
switch off the product and inspect for damage
before staring the product again. Refer
off the product on page 35 .
Switch on the product according to the instructions.
When the product is switched on; make sure to
keep your hands and feet away from the rotating
blades. Never put your hands and feet under the
product.
Never touch moving hazardous parts, such as the
blade disc, before it has come to a complete stop.
Never lift up the product or carry it around when it
is switched on.
The product must never be allowed to collide with
persons or other living creatures. If a person or
other living creature comes in the way of the
product, it shall be stopped immediately. Refer to
To stop the product on page 35 .
Do not put anything on top of the product or its
charging station.
16 - Safety
Park on page 34 or
2.3.2 Battery safety
To switch
For more information about the battery, refer to
on page 41
2.3.3 How to lift and move the product
Do not allow the product to be used with a
defective guard, blade disc or body. Neither should
it be used with defective blades, screws, nuts or
cables. Never connect a damaged cable, or touch
a damaged cable before it is disconnected from
the supply.
Do not use the product if the STOP button does
not work.
Always switch off the product when it is not in use.
The product can only start when the correct PIN
code has been entered.
The product must never be used at the same time
Schedule function so the
as a sprinkler. Use the
product and sprinkler never run simultaneously.
Schedule on page 29 .
Refer to
Husqvarna does not guarantee full compatibility
between the product and other types of wireless
systems such as remote controls, radio
transmitters, hearing loops, underground electric
animal fencing or similar.
The built-in alarm is very loud. Be careful,
especially if the product is handled indoors.
Metal objects in the ground (for example reinforced
concrete or anti-mole nets) can result in a
stoppage. The metal objects can cause
interference with the loop signal which then can
lead to a stoppage.
Operation and storage temperature is 0-50 °C /
32-122 °F. Temperature range for charging is 0-45
°C / 32-113 °F. Too high temperatures might cause
damage to the product.
WARNING:
Lithium-ion batteries can
explode or cause fire if disassembled, short-
circuited, exposed to water, fire, or high
temperatures. Handle carefully, do not
dismantle, open the battery or use any type
of electrical/mechanical abuse. Avoid
storage in direct sunlight.
WARNING:
The product must be
switched off before you lift it. The product is
switched off when the LED status indicator
is not lit.
1404 - 006 - 05.01.2021
Battery

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents